If that's on the viark then after you have set your usals up you have to go into each satellite and enable that satellite to use usals. Each satellite needs basically turning on to use the motor. You could also install a channel list and each satellite should be turned on.
Do you know which satellite the dish is parked at the moment? Can you select that satellite and try and get any type of signal on it? Your don't seem to have any quality on that transponder.
Also did you zero the motor before aligning on 0.8w?
Is the motor new?
Stupid question have you pushed the sat button on remote. Some of the viark remotes are different and did not have it. That changes the satellite you choose.
You need to start a seperate threadNo question is stupid at the moment
Yea im able to select a different sat but no movement, as i said i would expect to be able to move the dish pressing and holding the button on the motor?
These motors have physical stops to stop over roatiting but I wouldn't expect them to be set that near to zero. Worth checking,Yes brand new motor, never used, already at zero.
doneYou need to start a seperate thread