You dont need grafitti if you install 1.06I can't find the install Grafitti-dual-to-S2015_V3.3.3_07052020.apk and Ps4 file Do you have it master?
Graffiti is not a loader on 1.06It is already installed, but I cannot enter my cccam information, there is no add button on the screen, how do I enter cccam information?
There is no option to add your own cccam / oscam lines to the dual on the android side.It is already installed, but I cannot enter my cccam information, there is no add button on the screen, how do I enter cccam information?
It does with my channel list. You said you where trying it. I suspect your not using 1.06 though if you had loading issues with the list.My masters, I stopped dealing with the Android side until the new software came out, my engine does not turn to satellites at all...
Master, I am using your latest channel list, and 1.0.6. I am using the software, I have done all the reset operations, but the motor does not turn...It does with my channel list. You said you where trying it. I suspect your not using 1.06 though if you had loading issues with the list.
Have you entered your usuals coordinates.Master, I am using your latest channel list, and 1.0.6. I am using the software, I have done all the reset operations, but the motor does not turn...
Just wait for the next firmware update, there is a bug in the 1.0.4 and 1.0.6 firmwares that Qviart have confirmed and fixed.Master, I am using your latest channel list, and 1.0.6. I am using the software, I have done all the reset operations, but the motor does not turn...
If it will be possible for you to do a video of all the procedure for motorized dish how you do all the configuration.My lists also worked and moved to all the correct sats on 1.04 as well as 1.06, just a matter of manipulating the dual to scan the sats it has problems with moving to.
Once scanned it would then move to any sat on choosing a channel from those sat positions.
Would take too much of my time up.If it will be possible for you to do a video of all the procedure for motorized dish how you do all the configuration.
If its possible.
Have you installed ferrets latest channel lists. He spent a lot of time doing this list. If you install the list all you would need to do is go into your usals settings in the motor section of the menu and change it to your location. Other setting should be included in the channel list.If it will be possible for you to do a video of all the procedure for motorized dish how you do all the configuration.
If its possible.
Well it sounds as though people with the problem must wait for the next android release then. I have tm2300 motor and mine works with this version.@Ferret your list did not move my dish in 1.0.4 or 1.0.6, it also didn't move the dish of someone else I know in the same fw versions.
But did work on 2 other dish setups of people I know. 1 of which is using the same brand but an older version of the v-box that I use.
However the dish also wouldn't move when trying to do manual scans either (after a fresh install and without loading any channel list), even just going into the motor setup, and trying to move it from there, the most we could get is a few steps. The display of my v-box was constantly flashing on and off when connected to the Dual.
As said, it has been fixed in the next firmware update.