cyberworld23
Registered
- Messages
- 92
Can any one give me a direction to setup dm800 with diseqc 1x16?
How To Configure Diseqc 1x16 With Dm800
- Thread starter cyberworld23
- Start date
Here is an example:
Configuration Mode = advanced
Satellite = Hotbird 13E (change satellite name)
Voltage mode = Polarization
Tone mode = Band
LNB = LNB 1 ... 16 (change this)
DiSEqC mode = 1.1
Toneburst = None
Committed DiSEqC command = none
Fast DiSEqC = No
Sequence repeat = No
Command order = uncommited, commited, toneburst
Uncommitted DiSEqC command = Input 1 ... 16 (change this to be the same as LNB)
DiSEqC repeats = none
LOF = Universal LNB
Increased voltage = yes (if wire is long)
Polarity = Auto
Tone Amplitude = 800mV
Last edited:
- Messages
- 17,533
private4587
Registered
- Messages
- 24
Would this work on a two satellite system where one is motorised.
With a motorized system, you need to assign LNB1, port1 to the motorized system and program all the satellites on it.
private4587
Registered
- Messages
- 24
Thanks for your quick reply, after i assign LNB 1 to port 1 do I then set the satellites as above? sorry for all questions but cannot get my head around switches.
You can then assign as many satellites as ypu want to LNB1
Make sure that Diseq is set as 1.2 for this port only
The rest are set as 1.1
Make sure that Diseq is set as 1.2 for this port only
The rest are set as 1.1