I have a problem.
Someone gave me an xcam(angel hw version 1.0) to put new soft on it. So here it comes the story:
a.
I used cas3 and put 1.50 (block2) on it.After reload the version remained the same(1.48) So I double checked and I put the cam in my receiver and the soft remained the same.
Then I put softcam on it to block 14, everthing went ok and when I put the cam in the receiver no keys no providers.
b.
Then I put the pcmci loader to block0 everything went ok. The firmware changed 1.48 to 1.48-p. Ok then I used the laptop and do the same thing above (put the xcrytpto bin to block2 and the softcam to block 14), and again, the firmware remained (1.48-p) and no keys (zeros) and no providers(zeros) when I checked in my receiver
I think I did everything right. I would like to know why this cam is locked.
Someone gave me an xcam(angel hw version 1.0) to put new soft on it. So here it comes the story:
a.
I used cas3 and put 1.50 (block2) on it.After reload the version remained the same(1.48) So I double checked and I put the cam in my receiver and the soft remained the same.
Then I put softcam on it to block 14, everthing went ok and when I put the cam in the receiver no keys no providers.
b.
Then I put the pcmci loader to block0 everything went ok. The firmware changed 1.48 to 1.48-p. Ok then I used the laptop and do the same thing above (put the xcrytpto bin to block2 and the softcam to block 14), and again, the firmware remained (1.48-p) and no keys (zeros) and no providers(zeros) when I checked in my receiver
I think I did everything right. I would like to know why this cam is locked.