Qbox update issue
Hi ,
If any solution from the friends above does not work , do as follows.
Downgrade your Qbox Updater from ver. 108 to 107 .
Your RS232 cable must be null that means pins 2-3 3-2 5-5 4-6 7-8 etc. DB9fem to DB9fem.
Under windows device manager inspect serial port settings as Baud:115200 parity none , Stop bit 1, Flow none .The proper com port must be the same as Qbox Updater .
First we check if we are lucky .
Under windows command prompt type arp -a . This appears all
the connected devices IPs ( QBOX connected and turned on with cross lan cable ) . If you connect it to a switch hub check the
log of your device if leased any new IP.
If not listed there ( no luck ) then uncheck the Lan option as described and try to update with the 107 version it does always the job.
Note that you have to watch the console about "BAD CHECKSUM" .
If you see any you have to resend image even without closing the power switch .I suggest always due to update first to reflash the original image 155 and after then any other image .
Good Luck:thum:
JyapGR
GREECE