hi guys
i hope someone can help me on this mite be simple.
i have a motorised setup and a fortecstar passion receiver.
it was setup by a installer for me using disecq 1.2 to move motor and all was ok.
now i seem to lose satellite positions on some but not others.
in the end i have to fine tune them to get them back which is a pain.only to lose them again after a few days.
i tried with usals and wen it goes to the selected satellite i get no signal.
i know the dish hasnt moved because the only satellites i dont lose is thor 1w and telcom2d&ab 8w.
in all i had 16e/28e/19e/13e/9e/4.8e/7e
any ideas whats wrong will be appreciated
i hope someone can help me on this mite be simple.
i have a motorised setup and a fortecstar passion receiver.
it was setup by a installer for me using disecq 1.2 to move motor and all was ok.
now i seem to lose satellite positions on some but not others.
in the end i have to fine tune them to get them back which is a pain.only to lose them again after a few days.
i tried with usals and wen it goes to the selected satellite i get no signal.
i know the dish hasnt moved because the only satellites i dont lose is thor 1w and telcom2d&ab 8w.
in all i had 16e/28e/19e/13e/9e/4.8e/7e
any ideas whats wrong will be appreciated