how to return to an older bootloader version?

D

deli29

Registered
Messages
22
I, by mistake, updated my Yumatu IQ plus series(fta 3329C) receiver with the soft ``ALI3329C_globo_fta_amstar_emu_1.3.35`` and it seems to work ok but the problem is with the remote controller on which every button seems to work differently. Then I tried many times with different loaders to return to an older software, i.e. globo_3329C_EMU_1.2.84_AMSTAR but I got no success.
Everytime I try to put an older right software to the receiver I get the message ``the bootloader is older than the stb`s bootloader. So, can someone help me how to manage to do this and repair it to return to an intended bootloader ?
Thanks a lot in advance!!!
 
D

deli29

Registered
Messages
22
H1
At last I was able to correct my receiver according to
your instructions with the only difference that I chose upgrader ohne prufung and all chunk with no bootloader and now the remote controller works as before . Thank you very much , it was very helpful.
 
G

gentlesadique

Registered
Messages
96
I have similar problem, I have replaced my Ali3329E with Ali3329CX, and now nothing is working anymore. the receiver does not boot anymore. what shall i do. thank you
 
G

gentlesadique

Registered
Messages
96
I have similar problem, I have replaced my Ali3329E with Ali3329CX, and now nothing is working anymore. the receiver does not boot anymore. what shall i do. thank you
 
D

deli29

Registered
Messages
22
I think your problem is not similar as mine. If it does not boot at all I suppose you have to dump it with jtag if I am not wrong! What do you have on the front panel when you power it on?
If it is only a red light that is correctable only with jtag as far as I know! Masters can quote on this much more! Please wait for other advices and instructions that might come from other users, as well.
 
Last edited:
You must log in or register to reply here.
Top