You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Echolink EL 3020 ir plus
- Thread starter khalakov
- Start date
Sounds like you tried to install wrong firmware. you need to reinstall that as well. links somewhere in this sectionThx m8,
But i can not have the access , after powering on it freezes.
Whatever i do it says (status error).
Any idea? Please help.
Regards
marokino08
Super VIP
- Messages
- 7,462
Hi M8,
I always get this message (Target not connect or target is error status!)
Please any Idea.Where are you good guys.!
-First you make sure that the cable connected to a good computer and the receiver
-Secondly, the receiver has switched off the back of
- open the loader
- clic connecte
- Here Turn your receiver on the back
- final send the firmware
@marokino08
Thx m8,
That is exactly what we have done.The STB looks dead not responding.On the tv no signal on the receiver display when i switch on from the back i get this :Boot then on and it is frozen .The only buton tha works is on/off from the back nothing else responding.
Please any idea how to get it live again.
Regards.
Thx m8,
That is exactly what we have done.The STB looks dead not responding.On the tv no signal on the receiver display when i switch on from the back i get this :Boot then on and it is frozen .The only buton tha works is on/off from the back nothing else responding.
Please any idea how to get it live again.
Regards.
gadoonline
Registered
- Messages
- 2
Ihave the same problem somebody tell me how to jtag my echolink 3020 ir plus