diseqc setup?

[mickymcg]

hi lads
can any one help me with diseqc set up?
I have 90cm dish two lnb,s one at 19.2e and 13.0e,
using a vu+solo2 stb, In confifuration I set them up using advanced set up, is this right?

because when I change sat from 19 to 13 I can see dish move but it is a fixed dish? and nothing happens, but when I reboot the stb, chanel comes on??????
where am I going wrong??????
thank,s

 

[Brummie]

i think you need to set it up as simple Mode= DiSEqC A/B Port A 19.2 Port B 13

 

[mickymcg]

thanks will try that?

 

[mickymcg]

no,,, tryed that, did, not work,
now I am getting nothing?

 

[Brummie]

try simple toneburst A/B

 

[mickymcg]

no nothing?

 

[Jahu]

Do you have the right desecq port for each lnb?

Look at the pic, I have 4 LNB fixed dishes, easy setup, nothing advance.

If it does not work, connect the cable to LNB2, and configure LNB1 as loopthrough to LBN2. Of courser you setup just Simple A/B as you have 2 LNB.

A few months ago, I was loosing signal between satellites when i changed
channels, it turned out my Diseqc splitter was gone.
Try another disecq splitter if you can and see if it cures the problem.