Clarke-Tech (5000/5000C) EMU Help
- Thread starter d-ware
- Start date
anterocouto
Registered
- Messages
- 356
The Cccam works 100% but you must have a server
With the server, you put in that menu, the pass, username
and id, example gdtserver.dyn.dns.org, etc, etc
With the server, you put in that menu, the pass, username
and id, example gdtserver.dyn.dns.org, etc, etc
Last edited by a moderator:
Hello d-ware, you can find CCcam emu only with 204p firmware (maybe with 180p also, I don't know)
from menu 82*1 you have
aaaaaaServeraaaaaaaaaaProtocolaaaaaaaaaActiveaaaaaaaaaaaStatus
1aaConnection_0aaaaNewcamd/CCcamaaaaOn/OffaaaaDisconnected/Connected
.
.
24aConnection_23aaaNewcamd/CCcamaaaaOn/OffaaaaDisconnected/Connected
Enter in Connection_x, choose the protocol CCcam, insert id, password, Address and Port.
For Newcamd change DES-KEY only if from server you have other one than default.
Exit & save.
Make the connection, from OFF to ON if the Status is CONNECTED it's all ok.
You can use GREEN (to connect) and YELLOW (to disconnect) from you remote control.
Last edited:
What model do u have 5000C or 5000C+ i think the new software is for 5000C+
in number 82*1 signs *is 0
I know ... it was only to hide the right code.
made code 8281and not cccam in my receiver , why ?
Thank you my friend is also my receiver is 5000c, but this is not any hope for ccam?