Can't edit transponders on VT 7100 TS

[kare77]

Hi everybody! It's impossible to edit transponders (in Manual scanning). Every change that will be saved into memory will turn all other channels (including terrestrial channels) into Cable (no more satellite names in the channels list). "Cable" and "0 degrees" is written in the satellite names column. Even SW changes, factory defaults etc. do not help.
Can anybody help me?

 

[ersin69]

Hi everybody! It's impossible to edit transponders (in Manual scanning). Every change that will be saved into memory will turn all other channels (including terrestrial channels) into Cable (no more satellite names in the channels list). "Cable" and "0 degrees" is written in the satellite names column. Even SW changes, factory defaults etc. do not help.
Can anybody help me?

you have defekt settings!
load new one !

 

[stubyte]

New channel-list (settings)need for SW 02.57 and 02.58.
The old settings is not working with the 02.57 and above.
Create (or load) new settings

 

[kare77]

Thanks, Stubyte! Actually I have SW 02.55. No need even to renew the SW as it worked well, at least up to now. All changes in channels and transponders list I have made using STB only.
Starting this old procedure again after pressing the red key "Edits TPs" it takes now almost 40 sec to go on next step. Why so? And if you make now any changes after the red key pressing all satellites will turn to Cable (0 degrees) as I wrote before. Is it this you wrote Stubyte? Should I go on SW 02.58 with new settings? Sorry for stupid questions, I am quite inadequate in this yet!

 

[kare77]

Sorry Stubyte! You are absolutely right. The problem was in old settings only. Everything is OK now!
Thanks also to ersin69.