azbox premium Power supply: FAIL

[chritak]

i am trying to recover an azbox premium stuck on bootup using the recover guide, but when click open on putty and switch on azbox i get this message from putty:

yxosPc0 serial#e153f9baec7f4e68ad9aefa392 582dce subid 0xc4
xenv cs2 ok
Power supply: FAIL

any help will be very appreciable

bozo

 

[wahyura]

i am trying to recover an azbox premium stuck on bootup using the recover guide, but when click open on putty and switch on azbox i get this message from putty:

yxosPc0 serial#e153f9baec7f4e68ad9aefa392 582dce subid 0xc4
xenv cs2 ok
Power supply: FAIL

any help will be very appreciable

bozo

I had the same problem, anyone can help?

 

[gorski]

Change it...

 

[cata2ca]

Before changing it use a voltmeter and check if you have 12v and 24v. Pin out is shown on the PS.
I suspect you have a different problem.
My PS failed on both units and I reused the cable on PS (12 + 24) taped together
You have to match the amps too.
The message you copied is related to power supplied to yamon / JTAG i
nterface