AZbox Elite problem

M

memaliaj

Registered
Messages
16
I threw in usb this firmewere " ds_team_3.0_azbox_new2" for azbox elitehd.
shut down the receiver.
put usb with this firmwere.
on receiver.
in menu select upgrade from usb new version update.
ok.
when finished shut down the receiver from back button on-off.
In tv not open menu
now shows only ip 192.168.2.6 to receiver in front.
How can I fix it?
 
S

sergik

Member
Messages
58
To download the E2 should be used AZUp.

From the instruction

Put usb stick with patch.bin (e2)
switch on AZBox
Follow messages on GUI for update official FW (standard procedure)
After about 1 min , your receiver will reboot
Dont remove USB Stick from AZBox !!!
wait for IP adress on VFD of AZBox
Start latest ver of AZUp
Write IP adress in AZUp (see VFD)
Click on button Update
 
M

memaliaj

Registered
Messages
16
sergik said:
To download the E2 should be used AZUp.

From the instruction

Put usb stick with patch.bin (e2)
switch on AZBox
Follow messages on GUI for update official FW (standard procedure)
After about 1 min , your receiver will reboot
Dont remove USB Stick from AZBox !!!
wait for IP adress on VFD of AZBox
Start latest ver of AZUp
Write IP adress in AZUp (see VFD)
Click on button Update
Click to expand...
-------------------------------------------


I threw in usb this firmwere "ds_team_3.0_azbox_new2" for azbox elite.
-shut down the receiver.
-put usb with this firmwere.
-on receiver.
version in menu select new upgrade from usb update.
-ok.
when finished shut down the receiver from back button on-off.
In tv not open menu
now shows only ip 192.168.2.6 to receiver in front
When deciding to usb and open the receiver to do again firmwere in front read this :
-booting
-usb check
-escue mode?
-rescue mode
192.168.2.6 (here remains)
How can I fix it?
 
P

pe.tardo

Senior Member
Messages
140
memaliaj said:
-------------------------------------------


I threw in usb this firmwere "ds_team_3.0_azbox_new2" for azbox elite.
-shut down the receiver.
-put usb with this firmwere.
-on receiver.
version in menu select new upgrade from usb update.
-ok.
when finished shut down the receiver from back button on-off.
In tv not open menu
now shows only ip 192.168.2.6 to receiver in front
When deciding to usb and open the receiver to do again firmwere in front read this :
-booting
-usb check
-escue mode?
-rescue mode
192.168.2.6 (here remains)
How can I fix it?
Click to expand...

memaliaj said:
now in front write booting and thus remains.....(unchanged)
what to do?
Click to expand...

You MUST read all documentation about E2
before try to upgrade to it...

- reboot with E2 patch in USB (attached, of course!!)
- wait until IP appears again
- open JazUp (or AzUp) and input IP of AZ
- click "upgrade"
- You MUST CONNECT AZ + PC with a cable (not via the router)
and this cable must be "crossing" cable (same as if you connect
2 PC's)

I think this is all
 
You must log in or register to reply here.
Top