Yamal 601 @ 49° - 40 E- c band T2-MI discussion

ooOO_SORGOS_OOoo

Donating Member
Messages
3,047
hi dear

i have got t2-mi support sat receiver and c band lnb and dish antenna

how to setup this satellite?

i dont have got seperate for c band lnb
 

Ratzvan

Feed Hunter
Messages
22,693
hi dear

i have got t2-mi support sat receiver and c band lnb and dish antenna

how to setup this satellite?

i dont have got seperate for c band lnb
If your receiver is not an enigma2 and support T2-MI there are not particular problem.
Usually an automatic search is enough. Then yo ou can add manually the possible missing transponders.
O.L has to be set to 5150. Satellite signal is usually very strong there (y)
 

Ratzvan

Feed Hunter
Messages
22,693
I can't understand. You need a C-band lnb with a dielectric plate (40°E has circular polarization). If you have a C/KU band lnbf you can check both with a standard diseqc
 

fiji

Member
Messages
1,074
Hi!
T2-MI Receiver work with blind scan option those transponder can't scan channels in normal hd receivers .
You need this type Normal C-band LNB With dielectric plate For 40E satellite for other c-band reception use without dielectric plate .
boa atm
 

fiji

Member
Messages
1,074
40e- dielectric using yes?

other sats- not need? correct ?

thankyou friends
My Freind!
If you are using dielectric then normal H/V polarastion's signal go to weak or may be no signal
dielectric use for only L/R polarity circulation satellites . (Normal H/V No need)
if not available try it your own can make it easy with a plstic piece .
(Acrylic Sheet)
 

mrhardylima

Registered
Messages
243
The Dialectic Plate is used for only L/R satellites, for those like 55.5W that are H/V the plate is not needed.
You can take 40.5W as example that the plate must be used.
 

garatain

Registered
Messages
37
example with the vu+ duo 4k I have these channels but the t2 does not work black screen on sat 40.0 EST
 
Top