Tagteam3283
Registered
- Messages
- 10
hi guys,
My parents have clicked on the update firmware in the settings and now the box just keeps on cycling at boot.
I've tried the instructions I've listed below, I can see the reading from USB starts but then after 10 seconds it starts to boot into flash then start the boot loop again. Any idea please?
Tnx in advance
========
Step by step manual of how we can recover the receiver that has been left hanging in a loop.
With the word BOOT.
We download the Recovery Firmware, it is the original firmware of the DRS2 receiver
Once downloaded, we format a PENDRIVE USB to FAT32
Once we have the USB clean , we create a folder called: RomUpdate
And inside the folder we put the original Firmware that we have downloaded and we rename it: RomUpdate.bin
disconnect power cable to DRS2
Insert the USB stick In the VERTICAL BACK USB, next to the power socket, and NOT in the horizontal usb
Plug in the power cable and press and hold the «Power» button on the Viark DRS2 Front Panel (the display will alternate between «BOOT and UPDATE»
Then release the "Power" button and press the "CH +" button on the Front Panel until the "UPDATE" message remains solid.
We wait a few minutes while the receiver loads the file
the receiver will display UPdt while it continues updating.
This process takes a couple of minutes, be patient
Once finished the screen remains black, wait a little more it will restart.
eventually the box will start from fresh again.
My parents have clicked on the update firmware in the settings and now the box just keeps on cycling at boot.
I've tried the instructions I've listed below, I can see the reading from USB starts but then after 10 seconds it starts to boot into flash then start the boot loop again. Any idea please?
Tnx in advance
========
Step by step manual of how we can recover the receiver that has been left hanging in a loop.
With the word BOOT.
We download the Recovery Firmware, it is the original firmware of the DRS2 receiver
Once downloaded, we format a PENDRIVE USB to FAT32
Once we have the USB clean , we create a folder called: RomUpdate
And inside the folder we put the original Firmware that we have downloaded and we rename it: RomUpdate.bin
disconnect power cable to DRS2
Insert the USB stick In the VERTICAL BACK USB, next to the power socket, and NOT in the horizontal usb
Plug in the power cable and press and hold the «Power» button on the Viark DRS2 Front Panel (the display will alternate between «BOOT and UPDATE»
Then release the "Power" button and press the "CH +" button on the Front Panel until the "UPDATE" message remains solid.
We wait a few minutes while the receiver loads the file
the receiver will display UPdt while it continues updating.
This process takes a couple of minutes, be patient
Once finished the screen remains black, wait a little more it will restart.
eventually the box will start from fresh again.
Last edited: