Satellite reception problems

B

Biciosat

Registered
Messages
45
Hi all, I have a technical question.
With my TBS 5925 i have no reception problems except on one specific frequency on Eutelsat 7B satellite at 7 degrees east.
The frequency in question is 11153 V 7200 DVB S2 8PSK and I wanted to ask you if you too have reception problems only on that frequency and if so what could be the problem?
Thanks everyone in advance for the replies.
 
Last edited:
B

Biciosat

Registered
Messages
45
Yes i know that is not 24/7 on air but when this transponder is in use usually i've no signal or very weak signal, only on last tuesday i received with strong signal, but strong signal on this frequency is very rare, but I can not understand why only on that transponder.
Thanks for the answer
 
samir mokhtari

samir mokhtari

Feed Hunter
Messages
2,950
Biciosat said:
Yes i know that is not 24/7 on air but when this transponder is in use usually i've no signal or very weak signal, only on last tuesday i received with strong signal, but strong signal on this frequency is very rare, but I can not understand why only on that transponder.
Thanks for the answer
Click to expand...
Ithink Signial weak and Your Dish Small and Bad Lnb
Sise Dish ?
You have signial
7E
11050 H 4936
11055 H 4936 ?
 
samir mokhtari

samir mokhtari

Feed Hunter
Messages
2,950
Large Dish of pods that receives even Abs3W Feeds I expect you to have interference from the towers Try standing behind the dish on one of the directions, if the signal appears to you, which means that you have interference, use the Google Maps map and see if there are communication towers near your home.


I have a friend from Saudi Arabia who used to receive 100.5E C normally, but after installing the 5G towers, the satellite reception was lost, and several Filter 5G antennas were tried to no avail Same Stargold 500k . The interference is high on Cband satellites and to a lesser extent This prediction remains the closest to you. You have to experiment to make sure
 
Last edited:
B

Biciosat

Registered
Messages
45
Thank you very much for your comprehensive answer.
I also thought that it could be an interference because it is concentrated on a single frequency considering that the pointing is perfect and on other transponders the signal level is high, while on that frequency, although the feed is active, the signal appears to be non-existent. Thank you very much for your answers which confirmed my suspicions.
 
You must log in or register to reply here.
Top