Red exclamation mark

[jineffine]

Hi,

I tried to install OSCAM and apparently crashed something
My dreambox refuses to restart and I can't access the REscue menu

I start (power button + push the front start button) but a red exclamation mark displays and nothing happens

Could somebody support me to go to the Rescue menu in order to reflash?

Thank you !

JF

 

[jineffine]

I just success to avoid the red exclamation mark but the power button flashes red and the osd screen remains "black", does not enter in Rescue mode

I need "rescue"

 

[jineffine]

I finally succeeded to enter in telnet and launch the to-the-rescue command

sorry for disturbing (I was on since yesterday)

 

[johngav]

same problem

I'm in the same situation.
What command do I send to the box to get into rescue mode i've only ever done ftp and not into the telnet side.thanks john.g.

 

[cyberworld23]

It's almost happen in rescue loader lower than 103. As solution :

Flash the box via telnet / putty method.

Copy and paste each line into telnet / putty, pressing enter button after each.
Code:
echo "rescue" >.> /proc/stb/fp/boot_mode
reboot

Now enter the ip address of the receiver into a browser and flash the image as normal.

Ps
Remove . between >

 

[johngav]

How do I enter the following in telnet using DCC ?

echo "rescue" **** /proc/stb/fp/boot_mode
reboot

Is It as below?

rescue (enter)
proc (enter)
stb (enter)
fp (enter)
boot_mode (enter)
reboot (enter)

Hopefully this will put my receiver into flash / recovery mode.
Thanks

 

[cyberworld23]

How do I enter the following in telnet using DCC ?

echo "rescue" **** /proc/stb/fp/boot_mode
reboot

Is It as below?

rescue (enter)
proc (enter)
stb (enter)
fp (enter)
boot_mode (enter)
reboot (enter)

Hopefully this will put my receiver into flash / recovery mode.
Thanks

I've corrected above

Sent from my phone