Openbox [HD] Chat

justforyou

Registered
Messages
2
Hi covsoldier, i am using a v9 openbox. and i had problems with getting the right channels to, in my case it was HBO and FILM1.

But if you look up the "Antenna Setup" and then Transponder(32/97) which is in my case: astra 3, 12.129Ghz, SR:27500.

Well that transponder didn't had any signal, so leaving that window open on your box you can adjust the DISH till you get a signal rate.

Then rescan the whole satelite and there it was! Succces.

Well since this is very old box, i was just wondering if there is anything to stream channels to a pc?? like Openpli?

But i guess there isn't or i could not find any.
 

S ravichandran100

Registered
Messages
41
x5hd boxs authentication fail

problems my x5hd boxs authentication fail but connect internet not ok
3g modem use net cont good. My problems help'.
 

ferpodel

Registered
Messages
1
alguien ha encontrado algo de lo que me pasa que tengo el openbox v6s se me ve peor no se oye aque es el problema i porque
 

joseoli

Registered
Messages
1
My openbox x5 hd fails to initialize

Hi guys: my first post: P90000E HD pops a message on powerup :" Software authentication failed because
Security chip invalid or empty"

What doess this means?
Will it go if I reflash the firmware? Which vers?
Or is this box history...???

Thanks in advance. I use it for FTA G19 & AMC21

Regards from the Caribbean!
 

LATINOTV

Registered
Messages
18
YOUR RECIVER IS A CLONE


Hi guys: my first post: P90000E HD pops a message on powerup :" Software authentication failed because
Security chip invalid or empty"

What doess this means?
Will it go if I reflash the firmware? Which vers?
Or is this box history...???

Thanks in advance. I use it for FTA G19 & AMC21

Regards from the Caribbean!
 

Wasalex

Registered
Messages
2
HI EVERYONE!I have Openbox V6S(ALI 3511HD). Can I install firmware from GI micro plus or Amiko micro HD SE.If you can, how to do it(ID 0001)I would not want to kill the receiver.
 

dehur

Registered
Messages
1
openbox x3 that does not boot

Hi! I have an openbox x3 that does not boot. It only show the number 8 in display.

I saw in a forum which someone said it was corrected by running a fimware update by rs232.

Anyone can confirm that?

Thanks.

De Hur.
 

waldmeister

Donating Member
Messages
235
I have the Openbox SX6 and the coconut biss plug-in installed.
Now i need some help to enter biss keys for feeds with keys listed in the biss key section. How to enter them correctly?
I can enter 8 and 16 digits. Also Do i have to enter something on the right side? And how to activate the biss key
when you have the scramled feed on screen?
 

pierangelo74

Registered
Messages
78
Dears,
this is my first post and I would like to thank the site for what we all gave me in past..... :thum:

Now I would like to know more about the experience of Openbox sx6 users about tuner ability to tune and firmware availability and epg to improve the pvr ability...

Thanks

Pierangelo
 
Top