phinikarides@hotmail
Registered
- Messages
- 2
Hello all,
I am trying to setup a TERRA 10/1 SW101D DiSEqC on a DM500 but without any luck. I'm using non-standard configuration and setting the LNB's one at the time saving and then moving to the next one.
for the first satellite I select the proper satellite and for the lnb I choose LNB0, next page diseqc 1.1 NONE and uncommitted switch 1 and so on for the rest.
When I set them all up and I try to scan the channels the switch is stack on the first port and I can see the box downloading transponders from the first satellite even when scanning the other satellites. I have changed the cable from the box to the switch but still I get the same problem.
My Setup:
DM500
Processor STBx25xx 252MHz
Software Version: GEMINI release 3.1.0 22.02.2006
Any Ideas?
I am trying to setup a TERRA 10/1 SW101D DiSEqC on a DM500 but without any luck. I'm using non-standard configuration and setting the LNB's one at the time saving and then moving to the next one.
for the first satellite I select the proper satellite and for the lnb I choose LNB0, next page diseqc 1.1 NONE and uncommitted switch 1 and so on for the rest.
When I set them all up and I try to scan the channels the switch is stack on the first port and I can see the box downloading transponders from the first satellite even when scanning the other satellites. I have changed the cable from the box to the switch but still I get the same problem.
My Setup:
DM500
Processor STBx25xx 252MHz
Software Version: GEMINI release 3.1.0 22.02.2006
Any Ideas?