HDMU for AzboxHD

amyren

Registered
Messages
106
This image is also discussed in other threads, but I think it deserved its own tread:)

Look in the download section for latest image:
hxxp://www.hdmedia-universe.com/board/

I just installed HDMU version 15130. This is not the latest version, but I had it already downloaded on my harddrive so I decided to test it.
After installing I notice that the latest version is actually a bit smaller download, so it might have some more room for addons.

Flashing can be done with Azup or the MAT tool (se separate thread). Flashing went well. On startup it did and it did restore my old settings backup, automaticly without asking me for confirmation.

All in all I found this a good image so far. I had some work figuring out how to install a softcam on this, since there was no menu for downloading softcams. I had to install the files manually, after I found some files on the hdmu forum.

Some tools are not there by default, so the device mount manager, and cron and networkbrowser was not there initially. So my internal hdd is now mounted as /media/hdb1 instead of /media/hdd.
Also I had to figure out a way to mount my NAS disk, since I have my media archive there.

I now use this box as the second box, so that my kids have their own TV and can watch movies on it. And for that purpose it works ok so far. My reason for installing HDMU was that I experienced some issues with freezing with OpenSPA, so time will tell if this is more stable.

I have put a working version of oscam on dropbox. In the archive you will find the files needed. example config files are put in /usr/keys and must be modified to your needs.
Reboot the box after copying the files to the /usr/emu folder, and you should be able to se the cam available in the softcam manager (HDMU center)
https://www.dropbox.com/s/wdmt15i8ql5106u/oscam_HDMU_oscam.zip?dl=0
 

amyren

Registered
Messages
106
I noticed a minor "bug" on the HDMI output. This is when waking up from standby, the HDMI output will not initialize properly unless the TV is turned on first. I just get no output to my TV. Its easy to solve though, just by putting the azbox to standby again and turn it on after the tv is on will fix it.

BTW, on their forum there is a thread mentioning some audio issue with latest version 16733, and that this problem was not present in an earlier version. As a fix the poster did use libgstdvbaudiosink.so from ver 16587. The needed files are attached to this post at http://www.hdmedia-universe.com/board/showthread.php?10306-New-Image&p=118838&viewfull=1#post118838
Anyway it apears to be a minor issue, with audio delay with certain videofiles. Unless you experience these problems its nothing to worry about.
 
Top