drs 9500 via ci blocking trouble

gajagus

Registered
Messages
4
hello everyone from Serbia ..

i buy today this satelite receiver ...my trouble is that when i try to connect everything was fine until i lost my sound and possibility to change volume ....my receiver was start to work without sound and i change the channels it was without sound too...next whats happend was ..that at 13 channel because i was reset the receiver and scan the astra ....at the 13 channel my receiver was totaly blocked ..remote dead receiver dead picture frozen ...i cannot switch off until i shut the backside switch for 220 v ..and that way reset the receiver ....

my signal from antenna is bad i saw ..i will fix this tommorow but why is this happening ..i start to think that is something wrong with this receiver ...asking is there any way to fix this ...maby with softvare update or .. have you some suggest for me ....if you have please help :clapping: heeelp ...regards ...
 

gajagus

Registered
Messages
4
on my sony digital 801 works perfectly maby when a weather or raining have lost a signal but with this samsung everything was wrong
 

gajagus

Registered
Messages
4
if you think about LNB settings it was all set

power on ..
lnb lower lo 9750
lnb upper lo 10600
diseq off because i dont have
tone 22 khz set to auto
switch 0/12 set to 12 volt
no positioner ...

have you meaned this .......i have not found anything else for settings

smps voltage where to find this option in settings
 

deli29

Registered
Messages
22
I did not mean anything with software or settings. SMPS means the electric producing side of your receiver. When you open the cover of your receiver you will see the power side where the power cable is mounted. OK? If you are not an expert I have to warn you please dont try anything with that.

Well, for a quick solution just remove(delete) that channel which causes blocking by taking the lnb power to off option at first. Actually, which channel is that namely?
 
Last edited:
Top