Search results

You can change the sat position in the list by going to Antenna Config, press on Satellite, scroll right to Move, press Ok enter new position for selected sat.

Keep seeing this powervu question popping up so just checked the Qviart Dual and there are powervu key's in the patch menu (y)

There are some bugs to Iron out on the Android side which carries the FS we are waiting on a firmware update which should address some of those bugs. I've only dipped my toe into the e2 side but from what I know it's pretty much working fine.

Is that SP1 or SP2 or a combination of both?

If there's no SAT key you press EPG key instead.

Have you checked the other folders on you memory stick I've had it before that the recording starts before the programme starts and ends up in a different location with the title of the previous programme.

It's your choice both do the same thing it's mainly just the UI and the look of the devices that's different. I would say if you just require it for UK sat then buy as cheap as possible as these premium channels could go at anytime That's good as there aren't many and none on UK sat

I did the conversion to SP on a new 4K so went from three to two years but got one year IPTV as well (y)

Wipes your channel list so backup to USB first

I think it's power related but not the psu. I've had a 4k with similar issues and I traced the problem to a power regulator chip on the maiboard. Amongst other functions this chip reduces 12v down to 5.2v then elsewhere the 5.2v gets reduced down to 3.3v. The voltage at the usb's was wildly...

When it goes off try measuring the voltage on one of the USB sockets.

I thought you just had to rename bin file to Ali_update.bin to force update previous firmwares 🤔

Newer remotes don't have SAT button so you press OK button first then F1 for satellite list.

These motors have physical stops to stop over roatiting but I wouldn't expect them to be set that near to zero. Worth checking,

Also did you zero the motor before aligning on 0.8w? Is the motor new?

Are you pressing and holding or just pressing twice/ once and expecting the motor to move?

Try to downgrade to PT 1.15 but this needs to be renamed Ali_update.bin

I know mate was just curious as I have sat 4k that needed reflashed and didnt know which firmware it had on originally so flashed it with V4.0

Is it ok to put V8.0 original firmware onto any aged receiver?

Ok mate have a good holiday 👍