Search results

thanks again technomate motor tm-2300m3 confirmed that the motor when you give the GotoZero (or GotoReference) command go exactly to zero i reset the limits with the general Motor Reset, on the motor itself. for the 'last question I verified, the limits are disabling commands from the receiver...

thanks for the response Unfortunately, I have problems with both USALS commands, the manual MoveLeft or MoveRight commands, and the GotoPosXx commands. any other suggestions? tks

Sorry if this is not the correct section and for my English, but I wanted to ask why this motor stops at east 62 and west 40.5. I reset the limits and reset the motor from its button but the motor does not go over many thanks